Charger and Batteries Not Included Learn more and keep up to date on developments at @RNoksDesigns DeWalt DCB118 Battery Charger Mount/HolderPlace charger on mount base plate, insert “C” shaped retention clip and the charger will stay in place (neodymium magnets in clip and base keep the clip in place)Charger can easily be removed from mount to take to job siteOnly one hand needed to install/remove battery from chargerWall, ceiling, table mountable with 4 screw holesMultiple cable management options (routed through the inside of the mount or using built-in external clips on the outside of the mount) Optional DeWalt 20v Max Battery Mount/Holder – Available in Locking and Non-Locking Versions:Locking Version – Requires pressing of battery button to release. Battery can’t fall out even if upside-down.Non-Locking Version – Just slide battery off clamp, no need to fiddle with battery button. Perfect for wall mount in a shop where gravity will always keep battery in place All Battery Model Specs:Fits all DeWalt 20V and FlexVolt 60V Batteries.Wall, ceiling, table mountable with 2 screw holes per mount. Sized for up to #8 screws. Other TidbitsAll are made in USA by yours truly, 3D printed.Made with PETG filament which when compared to the commonly used PLA, offers improved strength and also high heat resistance (PLA has a poor resistance to heat and can cause deformation). Silly Fine PrintDesigned for genuine DeWalt DCB118 charger, will not work with other models/off-brands. Charger and batteries not includedDeWalt is a registered trademark of Black & Decker (U.S.) Inc.